Instructions / Assembly

å
Separate the EXTENSION SLIDES (U) from the EXTENSION RAILS (T) as
shown in the upper diaram below. Be prepared, the parts are reasy.
å
Fasten the EXTENSION RAILS (T) to the ENDS (A and B). Use four GOLD
5/16" FLAT HEAD SCREWS (PP).
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in
the enlared diaram. Then, slide the inner cartride of the EXTENSION
RAIL out to fi nd the other hole that lines up with the hole in the END. Turn
a SCREW into this hole.
å
Fasten six METAL BRACKETS (FF) to the ENDS (A and B). Use six
BLACK 9/16" LARGE HEAD SCREWS (NN).
å
NOTE: Be sure the edes of the METAL BRACKETS are even with the
edes of the ENDS.
Step 4
158002www.sauder.com/services
Pae 9
GOLD 5/16" FLAT HEAD SCREW
(4 used for the RAILS)
PP
Push the black lever in and pull the SLIDE from the RAIL.
BLACK 9/16" LARGE HEAD SCREW
(6 used for the METAL BRACKETS)
NN
A
B
T
T
FF
FF
(6 used)
T
U
Unfi nished ede
Surface with
TWIST-LOCK®
FASTENERS
Surface with
TWIST-LOCK®
FASTENERS
Unfi nished ede
Use this hole.