Instructions / Assembly
å
To insert the drawer into your unit, line up the EXTENSION SLIDES on the drawer
with the EXTENSION RAILS on the unit and push the drawer into the unit until the
drawer is fully inserted. The drawer will push in hard until it is all the way in, then it
will slide in and out easier.
å
Push the RUBBER SLEEVES (II) over the METAL PINS (HH). Insert the METAL PINS
into the hole locations of your choice in the ENDS (A and B) and UPRIGHT (C). Set
the ADJUSTABLE SHELVES (H) onto the METAL PINS.
å
Peel two FELT DISC from the FELT DISC CARD (1M) and stick them on the
DRAWER FRONT where it comes into contact with the ENDS (A and B).
Step 14
158002www.sauder.com/services
Pae 19
C
B
H
50 lbs.
40 lbs. total
20 lbs.
50 lbs.
H
20 lbs.
(8 used)
II
HH
1M
A