Instructions / Assembly

Step 7
å
Fasten the SHELF MOLDING (O) to the SHELF (E). Tihten three
TWIST-LOCK® FASTENERS.
å
NOTE: The SHELF MOLDING should overhan the top surface of the
SHELF slihtly.
å
Fasten the END MOLDINGS (S) to the ENDS (A and B). Use four BLACK
9/16" LARGE HEAD SCREWS (NN) throuh the METAL BRACKETS
and into the END MOLDINGS.
å
NOTE: The END MOLDINGS should overhan the inside surface of
the ENDS. There are no pre-drilled holes in the END MOLDINGS. The
SCREWS will tihten into the rooves.
å
Fasten a METAL BRACKET (FF) to the BOTTOM (F). Use a BLACK
9/16" LARGE HEAD SCREW (NN).
å
NOTE: Be sure the ede of the METAL BRACKET is even with the ede
of the BOTTOM.
å
Fasten the BASE (N) to the ENDS (A and B) and BOTTOM (F). Use
three BLACK 9/16" LARGE HEAD SCREWS (NN) throuh the METAL
BRACKETS and into the BASE.
158002 www.sauder.com/servicesPae 12
BLACK 9/16" LARGE HEAD SCREW
(8 used in this step)
NN
F
N
S
S
E
O
A
B
FF