User's Guide

Saucon Technologies IOTGTWY Page 8
During radio testing, please disconnect the diagnostic cable connector shown
above. Remove the PC and USB cable from the lab before performing radio
tests.
Open a VT100 emulator (putty, terraterm, etc). Plug the power into the IOTGTWY
box. The serial port settings are 115200,N,8,1
The diagnostic cable should be connected before powering the device. When
power is applied to the device, you will see the following on the serial console:
Pressing enter will bring up a diagnostic menu.
Press 2 for Diagnostic tests. The system displays diagnostic results.