Specifications

Chassis Specialist : Electric Power Steering
Page 25
Trouble codes can be cleared by using the Service Check Signal Circuit Method. The steps must be
followed exactly in order to clear the codes.
 With the ignition switch OFF ground pin 9 of the DLC
 The vehicle must be on the ground with the steering wheel in the straight ahead position
 Turn the ignition switch to the ON position. The EPS indicator should be illuminated for 6
seconds. Within 4 seconds of turning the switch on, turn the steering wheel left 45 degrees from
the straight ahead position and hold the steering wheel in that position until the EPS indicator
turns OFF
 Within 4 seconds of the EPS light turning OFF return the steering wheel to the straight ahead
position and release the steering wheel. The EPS light should illuminate within 4 seconds of
releasing the steering wheel
 Within 4 seconds of the light coming back on turn the steering wheel back 45 degrees to the left
and hold it in that position. The EPS light should go out after 4 seconds.
 Within 4 seconds of the light turning OFF return the steering wheel to the centre position and
release the wheel. The EPS light should blink twice within the next 4 seconds to indicate the
DTC’s have been cleared.
 After the EPS light has blinked twice turn the ignition switch to the OFF position
 Remove the jumper wire and verify all codes have been cleared.