Specifications

To manually shut off a remote start, do any of the
following.
• Aim the RKE transmitter at the vehicle and press
and release the remote start button.
• Turn on the hazard warning flashers.
• Turn the ignition switch out of LOCK/OFF position
and then back to LOCK/OFF.
The parking lamps turn off to indicate the engine is off.
After the engine has been started two times, or one
time with a time extension, the vehicle’s ignition must be
turned to ON/RUN using the key before the remote start
procedure can be used again. See Ignition Positions on
page 2-22 for information regarding the ignition positions
on your vehicle.
The remote vehicle start feature will not operate if any
of the follow occur:
• The remote start system is disabled through
the DIC.
• The vehicle’s key is in the ignition.
• The vehicle’s hood is open.
• The hazard warning flashers are on.
• The check engine light is on. See Malfunction
Indicator Lamp on page 3-37.
• The engine coolant temperature is too high.
• The oil pressure is low.
• Two remote vehicle starts, or one start with a time
extension, have already been provided for that
ignition cycle.
Vehicles that have the remote vehicle start feature are
shipped from the factory with the remote start system
enabled. The system may be enabled or disabled
through the DIC. See “REMOTE START” under DIC
Vehicle Personalization on page 3-50 for additional
information.
2-9