Navigation Manual

Radio Display Message Condition Action Required
XM Theftlocked Theft lock active The XM™ receiver in the vehicle may have previously been
in another vehicle. For security purposes, XM™ receivers
cannot be swapped between vehicles. If this message is
received after having your vehicle serviced, check with your
dealer/retailer.
XM Radio ID Radio ID label (channel 0) If tuned to channel 0, this message will alternate with the
XM™ Radio eight digit radio ID label. This label is needed
to activate the service.
Unknown Radio ID not known
(should only be if
hardware failure)
If this message is received when tuned to channel 0, there
may be a receiver fault. Consult with your dealer/retailer.
Check XM Receiver Hardware failure If this message does not clear within a short period of time,
the receiver may have a fault. Consult with your
dealer/retailer.
CD Player
The player can be used for CDs with conventional
CD audio, MP3, or WMA compressed files and
may have the capability to play DVD audio
and DVD video. See DVD Player on page 73 for
more information about DVD audio and video.
With the ignition on, insert a CD partway into the
slot, label side up. The player will pull it in and
the CD should begin playing. The navigation
system can be used while playing a CD.
When you insert a CD, the CD tab will display.
If you select an equalization setting for the CD,
it will be activated each time you play a CD.
If you turn off the ignition or radio with a CD in the
player, it will stay in the player. When you turn
on the ignition or radio, the CD will start playing
where it stopped, if it was the last selected
audio source.
As each new track starts to play, the track number
will appear on the display.
65