Get To Know Manual

Getting to Know Your AURA
12
Setting the Time
To set the time:
1. Turn on the radio.
2. Press the (Clock) button. Or, if
equipped, press the MENU button
until the clock option is displayed;
then press the pushbutton located
under the clock option label. The HR,
MIN, MM, DD, YYYY labels will
appear on the display.
3. Press the pushbutton under any of
the labels to be changed.
4. Press the pushbutton again, the right
Seek arrow or the FWD button to
increase the numbers. Press the left
Seek arrow or the REV button to
decrease the numbers. Rotating the
(Tune) knob also will increase or
decrease the selected label.
5. Press the Clock or MENU button
again to set the currently displayed
time and date.
See Section 3 of your Owner Manual.
With the
in-dash
6-disc
CD play-
er, you
cannot
directly
load a CD as in single-play systems.
Multiple-Disc CD Player
(if equipped)
To load a CD:
• To load a single CD, press and
release the LOAD button. Wait
for the display prompt to load the CD.
• To load multiple CDs, press and hold
the LOAD button for two sec-
onds. Follow the display prompts to
load each CD. Press the LOAD
button again to cancel loading more
CDs.
To play a specific CD:
• Press the pushbutton below the arrow
label on the display to select the
desired CD number.
To eject a CD:
• To eject the CD that is currently play-
ing, press the EJECT button
once.
• To eject all CDs, press and hold the
EJECT button for two seconds.
If a CD is not removed after several
seconds, it will be pulled back into the
player automatically.
See Section 3 of your Owner Manual.
Note: CDs with any affixed labels may
jam in the CD player. Label a CD using
a permanent marker. If more than one
CD is inserted into the slot at one time,
or if scratched or damaged CDs are
played, the CD player could be dam-
aged. When using the CD player, use
only CDs in good condition without
labels; load one CD at a time; and keep
the CD player and the loading slot free
of foreign materials, liquids or debris.
AURA 2007 A 6/14/06 8:44 AM Page 12