Navigation Manual

When getting started, you may set the navigation
system to your preference using various options. You
will also need to know how to perform various functions
to begin route guidance. Reference the following
topics for further information:
Setting Radio Station Presets
To set preset radio stations, do the following:
1. Press the power/volume knob to turn the system on.
2. Press the BAND hard key to access the band menu
and select the desired band (AM, FM1, FM2, XM1,
or XM2 (if equipped).
3. Use the tuning knob or the SEEK hard key arrows
to select a station.
4. Touch and hold one of the six screen buttons at the
bottom of the screen until you hear a beep or see
the station displayed on the selected preset button.
Setting the Time
To set the time, do the following:
1. Press the power/volume knob to turn the system on.
2. Press the CONFIG hard key.
3. Touch the Clock screen button.
4. Scroll through the Time Zones until the desired time
zone is highlighted.
5. Touch the Daylight Savings screen button.
The time is now set. Touch the Manual Adjust screen
button if you need to further adjust the time. The
radio will use the GPS satellite to set the time. The
vehicle needs to be in an open area to receive
the signal. See Global Positioning System (GPS) on
page 2-36 for more information.
Loading a DVD Map Disc
To load a DVD map disc, do the following:
1. Press the power/volume knob to turn the system on.
2. Press and hold the eject key to tilt the screen
forward.
3. Insert the DVD map disc into the DVD slot.
Notice: Pressing directly on the navigation screen
may cause damages. Repairs would not be
covered by your warranty. Do not press directly on
the navigation screen.
4. To close the screen, slightly push up on the two
outer top corners until the screen is in position,
then push the screen in, by pushing on the
four outer corners, until you hear a click.
5. A notice may appear. Touch the Next screen button
to proceed.
1-6