Owner`s manual
Editing
surround
decoders/sound
field
programs
Selling
sound
field
parameters
Sound
field
parameters
Although the field sound programs would satisfy you as
they are with the default parameters, you can arrange
sound effect or decoders suitable for acoustical conditions
of
sources or rooms
by
setting the parameters.
'"
'<il~
•
You
cannot configure the parameters when "Memory Guard"
is
set to
"On" (page 60).
1 Turn on the video monitor connected to this
unit.
2 Press
[IDON
SCREEN on the remote control.
The GUI screen appears on the video monitor.
3 Press []]]Cursor Vto select "Setup" and then
press
[]]]ENTER.
4 Press []]]Cursor
8,
/ Vto select "DSP
Parameter" and then press []]]ENTER.
,',
'<il~
• The default settings are marked with "*".
CINEMA DSP basic parameters
DSP Level
Adjustable range: -{jdB to OdB* to +3dB
Fine adjusts an effect level (level
of
the sound field effect
to be added).
You
can adjust the level
of
the sound field
effect while checking sound levels. Adjust "DSPLevel"
as
follows.
• The effect sound is too soft.
• There are no differences between effects
of
the sound
field programs.
~Increase
the effect level.
• The sound is dull.
• The sound field effect is added too much.
~Reduce
the effect level.
Notes
When the value
is
set to zero, the position
is
at the lowest.
The position gets higher
as
you increase the value.
_+-_Move
up
to the Ideal
dialogue position
--1--The
ideal dialogue
position
If
the dialogues are heard at the lower position
of
the video
monitor screen, increase the value
of
"Dialogue Lift".
Dialogue Lift
Choices: 0* to 5
Use this feature to adjust the vertical position
of
the
dialogues
in
movies. The ideal position
of
the dialogues is
at the center
of
the video monitor screen.
5 Press []]]Cursor
8,/
Vto select "Program
Name" and then press []]]Cursor
<l/
C>
to
select a sound field program to edit.
Sound field program
6 Press []]]Cursor
8,/
Vto select a parameter to
edit and then press []]]Cursor
<l/
C>
to
change the setting.
For details
on
functions and adjustable ranges
of
the
sound field parameters, see "Sound field parameters"
on this page.
Sound field parameters
~~<ir~
• Repeat steps 5 and 6 to change other sound field program
parameters.
7
To
turn off the GUI screen, press
[IDON
SCREEN.
To
initialize the parameters
of
the selected sound field
program, press []]]Cursor Vrepeatedly to select
"Initialize" and then press []]]Cursor
C>.
Then, press
[]]]Cursor
C>
again to execute the initialization or
[]]]Cursor
<l
to cancel it.
• This setting is available only when "Extra Speaker Assignment" is set to
"Presence" (page 56).
•
You
cannot move the dialogue position down from the initial dialogue
position.
3D DSP
Choices:
On*,
Off
When CINEMA DSP 3D is enabled, sets whether to use
sound field programs in 3D mode.
50 En