Owner`s manual
PREPARATION
Preparing
remote
control
Install
g
batleries
in
the
remote
contro
1 Take
off
the
battery
compartment
cover.
2
Insert
the
two
supplied
batteries (AAA, R03,
UM-4)
according
to
the
polarity
markings
(+
and
-)
on
the
inside
of
the
battery
compartment.
3 Snap
the
battery
compartment
cover
back
into
place.
Notes
• Change all batteries if you notice the following conditions:
- the operation range
of
the remote control narrows
- the transmit indicator does not flash or
is
dim
• Do not use old batteries together with new ones.
This may shorten the life
of
the new batteries or cause old batteries
to
leak..
• Do not use different types
of
batteries (such as alkaline and
manganese batteries) together. Specification
of
batteries may be
different even though they look the same.
• If you find leaking batteries, discard the batteries immediately,
taking care not to touch the leaked material. If the leaked material
comes into contact with your skin
or
gets into your eyes or mouth,
rinse
it
away immediately and consult a doctor. Clean the battery
compartment thoroughly before installing new batteries.
• Dispose
of
the old batteries correctly in accordance with your local
regulations.
• If the remote control
is
without batteries for more than 2 minutes,
or
if
exhausted batteries remain in the remote control, the contents
of
the memory may be cleared.
In
such a case, install new batteries
and set the remote control code.
Using
the
remote
control
The remote control transmits a directional infrared ray. Be
sure to aim the remote control directly at the remote
control sensor on this unit during operation.
Remote
control
sensor
window
;Notes
• Do not spill water or other liquids on the remote control.
• Do not drop the remote control.
•
Do
not leave or store the remote control in the following conditions:
- places
of
high humidity, such as near a bath
- places
of
high temperatures, such as near a heater or stove
- places
of
extremely low temperatures
- dusty places
,I,
~ti>~
•
You
can operate external components with this remote control
by
setting
the remote control code (page 63).
9En
I