User manual

Removal of freezing baskets and glass shelves from the freezer
2
1
Some of the freezing baskets have a limit
stop to prevent their accidental removal or
falling out. At the time of its removal from
the freezer, pull the basket towards yourself
and, upon reaching the end point, remove
the basket by tilting its front upwards
At the time of putting it back, slightly lift the
front of the basket to insert it into the freez-
er.
Once you are over the end points, push the
basket back in their position.
1
2
1
The appliance is equipped with shelf stops
to secure the shelves.
The shelves must be lifted up (1) on each
side and than pulled outwards (2).
The glass shelves equipped with expander
rollers are secured with locking pins.
2
1
1
1
To remove them proceed as follow:
1. Use a screwdriver to loosen the locking
pin on each side on the expander roll-
er.
2. Then pull out both locking pin (1).
3. Then pull the glass shelf outwards (2).
HELPFUL HINTS AND TIPS
Normal Operating Sounds
• You may hear a faint gurgling and a bub-
bling sound when the refrigerant is pum-
ped through the coils or tubing. This is
correct.
• When the compressor is on, the refriger-
ant is being pumped around and you will
hear a whirring sound and a pulsating
noise from the compressor. This is cor-
rect.
• The thermic dilatation might cause a sud-
den cracking noise. It is natural, not dan-
gerous physical phenomenon. This is
correct.
• When the compressor switches on or
switches off, you will hear a faint "click" of
the temperature regulator. This is correct.
58