O179GSA++N User manual Freezer
Contents Safety information Control panel First use Daily Use Helpful Hints and Tips 2 4 6 6 6 Care and cleaning What to do if… Technical data Installation Environmental concerns 7 8 10 10 12 Subject to change without notice Safety information In the interest of your safety and to ensure the correct use, before installing and first using the appliance, read this user manual carefully, including its hints and warnings.
Warning! Any electrical component (power cord, plug, compressor) must be replaced by a certified service agent or qualified service personnel. 1. Power cord must not be lengthened. 2. Make sure that the power plug is not squashed or damaged by the back of the appliance. A squashed or damaged power plug may overheat and cause a fire. 3. Make sure that you can come to the mains plug of the appliance. 4. Do not pull the mains cable. 5. If the power plug socket is loose, do not insert the power plug.
shall be disposed according to the applicable regulations to obtain from your local authorities. Avoid damaging the cooling unit, especially at the rear near the heat exchanger. The materials used on this appliance marked by the symbol are recyclable. Environment Protection This appliance does not contain gasses which could damage the ozone layer, in either its refrigerant circuit or insulation materials. The appliance shall not be discarded together with the urban refuse and rubbish.
Functions Menu By activating the key (D) the functions menu is operating. Each function could be confirmed by pressing button (E). If there is no confirmation after some seconds the display will go out from the menu and return in normal condition.
Then it returns on the normal operation showing the temperature of the selected compartment. During the alarm phase, the buzzer can be switched off by pressing button (E). First use Cleaning the interior Before using the appliance for the first time, wash the interior and all internal accessories with lukewarm water and some neutral soap so as to remove the typical smell of a brandnew product, then dry thoroughly. Important! Do not use detergents or abrasive powders, as these will damage the finish.
• the freezing process takes 24 hours.
• remove all food • defrost 4)and clean the appliance and all accessories • leave the door/doors ajar to prevent unpleasant smells. If the cabinet will be kept on, ask somebody to check it once in a while to prevent the food inside from spoiling in case of a power failure. What to do if… During operation of the appliance some smaller but annoying trouble can often occur, which does not require calling a technician out.
Problem The temperature in the freezer is too high. Possible cause Solution The door is not closed correctly. Refer to "Closing the door". The food temperature is too high. Let the food temperature decrease to room temperature before storage. Food is too near to each other. Store food so that there is cold air circulation. Large quantities of food to be fro- Insert smaller quantities of food to zen were put in at the same time. be frozen at the same time. The appliance does not operate.
Technical data Dimension Height 1600 mm Width 600 mm Depth 630 mm Rising Time 21 h The technical information are situated in the rating plate on the internal left side of the appliance and in the energy label. Warning! It must be possible to disconnect the appliance from the mains power supply; the plug must therefore be easily accessible after installation. 10mm Location The appliance should be installed well away from sources of heat such as radiators, boilers, direct sunlight etc.
Slacken the screws and insert the spacer under the screw head, then retighten the screws. d d • Remove both covers of the hinge (3) . • Unscrew the upper hinge and remove it (1-2). • Unscrew the screw and remove the door stopper (4). 3 Door reversibility Before carrying out any operations, remove the plug from the power socket.
• Fix the handle on the opposite side, insert the plastic plugs into the holes left open that can be found in the instruction for use bag. E E E F F F D F • Re-insert the door . • Pay attention that the front board of the doors are parallel to the front board of the top. • Fix the door stopper (4) on the opposite side. • Position and fix the upper hinge (1-2) on the opposite side . • Re-insert both hinge covers (3). • Lift up the appliance to vertical position.
Info Service Postfach 2550, 4002 Basel Info-Tel. 0848 888 444* www.coop.ch *Nationaler Tarif/Tarif national/Tariffa nazionale Servicestelle Wangen Postfach 4612 Wangen bei Olten Fax 062 206 33 12 Service après-vente Ch.
