Operator`s manual

Batch Separator
Command Structure <ESC>Ia
a = 1 Batch Marker- Prints a black mark on the edge of
the first tag of the print job.
b = 1 Batch Separator - Cuts the first tag in a print job
2 mm longer and the following tag 2 mm shorter.
Example: See Above
Placement: Before or after job data stream
Default: None
Command Function To separate tag batches in the stacker.
Printer Input
<ESC>A<ESC>V0100<ESC>H0300< ESC>XMJob1<ESC>Q5<ESC>Z
<ESC>A<ESC>I1<ESC>Z
<ESC>A<ESC>V0100<ESC>H0300<ESC>WB1JOB2<ESC>Q5<ESC>I1<ESC>Z
Printer Output 1. If a Batch Separator tag is specified, the first 2 tags of the print job
are used. If these 2 tags are not to be used, you must increase
your print quantity by 2 tags to get the desired number of usable
tags.
2. If the Batch Separator Tag command is used in a separate print
job, you must specify a quantity of at least 2 tags or the command
will be ignored.
Section 5. Programming Reference
Page5-169001038Rev.DSATOXLSeriesPrinters