Operator`s manual

COMMAND DEFAULT SETTINGS
There are some types of commands that must have a value specified before a label
can be printed. If the data stream does not contain these commands, a “default” value
is assumed. The commands and the corresponding default values are:
COMMAND DEFAULT NOTE
Print Rotation 0° (1)
Vertical Reference Point 0 (1)
Horizontal Reference Point 0 (1)
Character Pitch 2 (1)
Base Reference Point H=1, V=1 (2)
Character Expansion 1 (1)
Print Darkness 2 (1)
Print Speed XL400 6 ips (2)
Print Speed XL410 4 ips (2)
Offset (3)
NOTES:
(1) The settings for these commands will revert to the default value when the printer
receives an <ESC>Z or an <ESC>*.
(2) The values transmitted with these commands will remain in effect until a new
command is received.
(3) The default value for offset depends upon the type of media selected.
Side Notch Tag
Label I-Mark
Label Gap
Center Hole Tag
Side Hole Tag
I-Mark Tag
XL400 0.00 +040 4.5mm
XL410 0.00 +060 4.5mm
E
H=200
V=800
Base
Ref
Point
Label
Feed
Direction
“%1”
Section 5. Programming Reference
SATOXL SeriesPrinters9001038 Rev. DPage 5-9