Operator`s manual

Cut Roller
10. Moisten a cotton swab with SATO
Thermal Print Head and Platen
Cleaner.
11. Carefully clean the entire surface of
the Cut Roller. Rotate the roller to
expose the complete surface while
cleaning.
12. Remove the Sensor Plate by pressing
down on the detent latch located
inside the Sensor Plate mounting
Pitch Sensor
Sensor
Plate
13. Moisten a cotton swab with SATO
Thermal Print Head and Platen
Cleaner.
14. Clean the Pitch and I-Mark sensors.
4. Reinstall the Sensor Plate by sliding it
back on the shaft.
I-Mark Sensor
Pitch Sensor
Section 4. Cleaning and Maintenance
Page 4-49001038 Rev. DSATOXL SeriesPrinters