Operator`s manual

CLEANING THE PRINT HEAD, PLATEN, ROLLERS AND SENSORS
Supplies needed: SATO SA070 Cleaning Kit
Ribbon
Roller
1. Power the printer Off.
2. Open the print head by rotating the
green Head release lever
counterclockwise.
3. Moisten a cotton swab with SATO
Thermal Print Head and Platen
Cleaner.
4. Carefully rub the cotton swab over the
length of the print head and along
and around the Platen and Ribbon
Rollers.
Print
Head
Platen
Roller
Nip Roller
Label Sensor
Tag Sensor
Feed Roller
5. Open the Media Hold Down by lifting
up on the green plate marked “Push”.
6. Moisten a cotton swab with SATO
Thermal Print Head and Platen
Cleaner.
7. Use the swab to clean the Nip Roller,
Feed Roller, Label Sensor and Tag
Sensor.
8. Place the Cleaning Sheet under the
Print Head (dull side up) and close
the Print Head.
Cleaning Sheet
Print Head
9. Slowly pull the Cleaning Sheet out of
the printer.
Section 4. Cleaning and Maintenance
SATOXL SeriesPrinters9001038 Rev. DPage 4-3