Operator`s manual

Cut Position
When the printer is in the Cut mode (cutter enabled), the Cut Offset is set using the
LCD Service Mode to correctly position the label for cutting. Once the correct Cut
Offset is obtained, it may be necessary to adjust the position slightly.
This is done with the CUT POSITION potentiometer on the front panel. When turned
all the way clockwise the cut position is moved down the tag 3.75mm and when
turned all the way counterclockwise, the cut position is moved 3.75mm toward the
top of the tag.
1. Turn the printer on.
2. Press the START/STOP key to place the printer in the OFF LINE status.
3. Press the FEED key to feed out a blank label.
4. Adjust the position using the Cut Position potentiometer on the Control panel and feed
another label by depressing the FEED key.
5. When the adjustment is correct, turn the printer off.
Default Offset Settings, XL400
Section 3. Printer Configuration
Page 3-209001038 Rev. DSATOXL SeriesPrinters