Operator`s manual

USER TEST PRINT
This option allows you to print a Test Label. It is recommended that you print a Test
Label after you have changed any of the settings in the User Mode. The test label
allows you to verify that you indeed did make the desired changes. To enter the User
Test Print Mode, apply power to the printer while simultaneously pressing the FEED
key. The printer will “beep” once and display the following message on the LCD panel:
1. Pressing the START/STOP key will cause the printer to start printing test labels.
2. If you wish to pause the printer after it starts printing labels, pres the START/STOP
key to place it Off Line. Pressing the START/STOP key again will place the printer
back On Line and the printer will resume printing test labels.
3. If you wish to stop the test label print, pause the printer and then turn power off
without placing it On Line.
SERVICE TEST PRINT
This option allows you to print a Service Test Label. It is recommended that you print
a test label after you have changed any of the settings in the Service Mode. The Test
Label allows you to verify that you indeed made the desired changes. To enter the
Service Test Print Mode, apply power to the printer while simultaneously pressing the
FEED and MEDIA TYPE keys. The printer will “beep” once and display the following
message on the LCD panel:
1. You can select either a Small or Large label using the START/STOP key. The Large
selection assumes you have labels at least 3.1 inches wide loaded in the printer. If
your labels are smaller, you must select Small as the head can be easily damaged if
nothing is under the print area to dissipate the heat from the print head.
2. If Large is selected, pressing the FEED key will cause a complete Service Test label to
be printed. If Small was selected, you will get the following screen:
3. Use the START/STOP key to select the correct size label. Each time the
START/STOP key is pressed, the indicated label size will increase by 1 cm. The
maximum size is 10 cm.
USER TEST PRINT
SERVICE PRINT
SMALL LARGE
PRINT SIZE
0
4cm
Section 3. Printer Configuration
SATOXL SeriesPrinters9001038 Rev. DPage 3-17