Operator`s manual

2. Use the START/STOP key to select the type of media to be used.
3. Once the correct media type is shown in the display message, pressing the FEED key
will advance to the Backfeed Offset direction adjustment.
4. Use the START/STOP key to step the underline cursor to either the positive (+) or
negative (-) selection.
5. Once the correct direction setting is underlined, pressing the FEED key will advance to
the Backfeed Offset adjustment.
6. Use the START/STOP key to step the counter to the desired position. The display will
increment one step for each time the START/STOP key is pressed. If the
START/STOP key is held pressed for more than two seconds, it will automatically
go into the fast scroll mode. The reading will advance to a setting of 99 dots after
which it will automatically wrap and start at “00” again. The Backfeed Offset
Direction set in the previous step will be displayed in front of the Backfeed Offset
setting.
Counter Clear
The Counter Clear Service Mode is used to reset the internal printer counters to zero.
This allows the user to keep track of the number of centimeters of label material that
has passed through the printer, how many labels have been dispensed or how many
labels have been cut.
The counters are identified in the display as:
NON: None (default)
ALL: Clears all counters
HEAD: Clears Head Counter
CUT: Clears Cutter Counter
1. Press the FEED key to enter the desired Service Mode.
2. Use the START/STOP key to step the underline cursor to the counter(s) to be reset.
The default position is None (NON) of the counters. Use the START/STOP key to
advance the underline cursor to the desired position.
3. Once the correct setting is underlined, pressing the FEED key will clear the selected
counter and advance the display back to the SETUP SENSOR display.
Exit
To exit the Service Mode, remove power from the printer and the settings will be
stored in non-volatile memory.
COUNTER CLEAR
NON
Section 3. Printer Configuration
Page 3-169001038 Rev. DSATOXL SeriesPrinters