Operator`s manual

8. Once the setting is correct, pressing the FEED key will advance to the Cut Offset
display.
Cut Offset
The Cut Offset is the distance from the reference line (see page 3-20)of a label or tag
to the desired cut position. The cut position of the label or tag can be adjusted
relative to the reference line +/- 99 dots in increments of 1 dot using the following
procedure (1 dot = .005" for the XL400 and .0033" for the XL412). Once the position
is set, it can be adjusted +/- 3.75mm using the CUT POSITION potentiomenter on
the Control panel (see page 3-20).
1. Press the FEED key to enter the desired Service Mode type.
2. Use the START/STOP key to select the type of media to be used.
3. Once the correct media type is shown in the display message, pressing the FEED key
will advance to the Cut Offset direction adjustment.
4. Use the START/STOP key to step the underline cursor to either the positive (+) or
negative (-) selection. A positive selection moves the cut position towards the top of
the tag while a negative selection moves the cut position toward the bottom of the
tag.
5. Once the correct direction setting is underlined, pressing the FEED key will advance to
the Cut Offset adjustment.
6. Use the START/STOP key to step the counter to the desired position. The display will
increment one step for each time the START/STOP key is pressed. If the
START/STOP key is held pressed for more than two seconds, it will automatically
go into the fast scroll mode. The reading will advance to a setting of 99 dots after
which it will automatically wrap and start at “00” again. The Cut Offset Direction set
in the previous step will be displayed in front of the Cut Offset setting.
Backfeed Offset
The Backfeed Offset is the distance the label or tag is to be retracted after it is cut. It
aligns the print and cut position of the first tag after tags have been ejected from the
printer. The backfeed distance can be adjusted relative to the reference line +/- 12
dots (+/- 18 dots for the XL410) in increments of 1 dot using the following
procedure (1 dot = .005" for the XL400 and .0033" for the XL410). A minus value
retracts the tag less and a positive value pulls the tag further back into the printer.If a
value greater than 12 (or 18) is entered, an error will occur.
1. Press the FEED key to enter the desired Service Mode type.
CUT OFFSET
CENTER HOLE
+99
BACKFEED OFFSET
CENTER HOLE
+10
Section 3. Printer Configuration
SATOXL SeriesPrinters9001038 Rev. DPage 3-15