Operator`s manual

SERVICE MODE
A Service Mode is provided to make adjustments that require only occasional
changes. Since they affect the basic operation of the printer, the procedure for
entering this mode is designed to prevent someone from accidently changing the
settings.
To enter the Service Mode, the printer is powered on while pressing the
START/STOP simultaneously with the MEDIA TYPE key while powering the
printer on.The printer will “beep” one time and display the first configuration
selection on the LCD panel. You select the type of adjustment by pressing the
START/STOP key. Each time the START/STOP key is pressed, the Service Mode
display will be cycled to the next selection. The type of adjustments that can be made
in the Service Mode are:
• Sensor Setup
• Pitch Offset
• Cut Offset
• Backfeed Offset
• Clear Counter
From the Service Mode type display, the settings are accessed in sequence by pressing
the FEED key. Once you have cycled through all the adjustments for the Service
Mode type, pressing the FEED key will sequence you to the next Service Mode type.
Service Mode
Setup Sensor
Service Mode
Pitch Offset
Service Mode
Cut Offset
Service Mode
Backfeed Offset
Service Mode
Counter Clear
Center Hole Tag
I-Mark Tag
Side Hole Tag
R-Corner Tag
Label Gap
Label I-Mark
Start/Stop to
Select Settings
Center Hole Tag
I-Mark Tag
Side Hole Tag
R-Corner Tag
Label Gap
Label I-Mark
Start/Stop to
Select Settings
Center Hole Tag
I-Mark Tag
Side Hole Tag
R-Corner Tag
Label Gap
Label I-Mark
Start/Stop to
Select Settings
Gap
I-Mark
Start/Stop to
SelectSetting
All
None
Head
Cut
Start/Stop to
Select Settings
Start/Stop to Select
Service Mode Type
Feed Feed Feed Feed Feed
Feed Feed Feed Feed Feed
Feed Feed Feed Feed Feed
Section 3. Printer Configuration
SATOXL SeriesPrinters9001038 Rev. DPage 3-11