Operator`s manual

7. The underline cursor is now positioned under the least significant digit of the H offset
setting. The horizontal offset will increase each time the START/STOP key is
pressed. If the START/STOP key is pressed and held down, the value will count up
rapidly.
8. Once the correct setting is displayed, press the FEED key to accept the setting advance
to the next adjustment.
Zero Slash Setting
This setting determines if a zero is printed with a slash or without a slash. This setting
can also be controlled via softwware commands. When YES is selected, the XU, XS,
XM, XB, XL and vector fonts will have a slash through the center of the zero character.
1. Use the START/STOP key to step the underline cusor to either the YES or NO
selection.
2. Once the correct setting is underlined, pressing the FEED key will cycle back to the
Exit
You exit from the USER MODE by removing power from the printer. At this time the
values selected will be stored in non-volatile memory.
ABCDEFG
ABCDEFG
Original Print
Line Position
Moved with both
Vertical and (+)
Horizontal Offset
Feed Direction
Inside Edge
ZERO SLASH
YES NO
Section 3. Printer Configuration
Page 3-109001038 Rev. DSATOXL SeriesPrinters