Operator`s manual

USER MODE
To enter the USER mode, power the printer on while pressing the START/STOP
key. After the printer beeps, release the START/STOP key.
Pressing the FEED key will result in the printer now displaying the first USER mode
adjustment (Print Darkness).
Print Darkness Setting
There are three Darkness (or heat range) settings on the XL400/410 (1, 2 and 3).
The higher numbers represent darker settings. The current setting is indicated by an
underline under one of the range settings. To change the setting:
1. Use the START/STOP key to step the underline cursor to the desired setting.
2. Once the correct setting is underlined, press the FEED key to advance to the next
adjustment.
Note: This setting can be orverriden by software commands (see Print Darkness page
5-49.
After setting the heat range with this command, finer adjustments can be made using
the PRINT potentiometer adjustment on the Adjustment panel. See page 4-1 for
additional information on how to make this adjustment.
USER MODE
PRINT DARKNESS
1
23
Section 3. Printer Configuration
Page 3-89001038 Rev. DSATOXL SeriesPrinters