Operator`s manual

PRINTER ADJUSTMENTS
The LCD Panel on the XL400 and XL410 is used by the operator to manually enter
printer configuration settings. Many of the settings can also be controlled via software
commands and in the case of conflict between software and control panel settings,
the printer will always use the last valid setting. If you load a label job that includes
software settings and then enter a new setting via the Operation Panel, the manually
set values will be used by the printer. If you set the values manually and then
download a job with software settings, the software settings will be used.
NORMAL MODE
When the printer is powered on, the ON-LINE LED will be illuminated and the
readout should display the following message:
The LCD Panel will display the ON LINE status on the top line of the display and the
the bottom line will contain the label quantity status. The ON LINE message will be
changed to OFF LINE whenever the printer is switched OFF LINE by depressing the
START/STOP key. As soon as a print job is received, the left quantity message will
indicate the number of labels to be printed and the right quantity message the number of
labels printed since power up. As soon as the label job begins to print, the display will
indicate the number of labels remaining in the print job that remain to be printed. As
each label in the print job is printed, the quantity to be printed (left) will decrement
and the quantity printed (right) will increment.
When the printer is first taken offline by pressing the START/STOP key once. The
ON LINE LED will go off and the display will change to:
ON LINE
000000 000000
CENTER HOLE TAG
000000 000000
Section 3. Printer Configuration
Page 3-69001038 Rev. DSATOXL SeriesPrinters