Operator`s manual

Default Settings
Switch Selections - All switches are placed in the Off position (default) for shipping.
This will result in the following operating configuration:
Communications
Protocol:
Mode:
Head Check:
Receive Buffer:
Pitch Check:
8 data bits, no parity, 1 Stop bit, 9600 Baud
Ready/Busy, Standard Protocol Codes
Thermal Transfer
Disabled
Single Job
Sensor Used
Software Default Settings - The printer stores the software settings upon receipt and
uses them until they are again changed by receipt of a command containing a new
setting. These settings are stored in non-volatile RAM and are not affected by
powering the printer off. The printer may be reset to use the default software settings
by depressing the FEED and START/STOP keys simultaneously while powering the
printer on. This will result in the following default configuration:
XL400 XL410
Print Darkness 22
Print Speed 6 inches per second 5 inches per second
Print Reference Vertical = 001
Horizontal = 001
Vertical = 001
Horizontal = 001
Media type Center hole Tag Center Hole Tag
Cutter Enabled Enabled
Zero Slash Slash
Once the default operation is completed, a “SATO DEFAULT COMPLETED” message
will be displayed on the LCD panel or a single “beep” will be heard if the printer does
not have an LCD panel. The printer should be powered off while this message is being
displayed (or after the “beep” is heard. This saves the default settings in the EEPROM
where they will be automatically loaded the next time the printer is powered on.
SATO DEFAULT
COMPLETED
Section 3. Printer Configuration
SATOXL SeriesPrinters9001038 Rev. DPage 3-5