Operator`s manual

Stop Bit Selection (DSW1-4) - Selects the number of stop bits to end each byte
transmission.
Baud Rate Selection (DSW1-5, DSW1-6) - Selects the data rate (bps) for the
RS232 port.
Protocol Selection (DSW1-7, DSW1-8) - Selects the flow control and status
reporting protocols. See Section 6: Interface Specifications for more information.
Printer Set Up
Print Mode Selection (DSW2-1) - Selects between direct thermal printing on
thermally sensitive paper and thermal transfer printing using a ribbon.
Reserved (DSW2-2) - Reserved for future use
Head Check Selection (DSW2-3) - When selected, the printer will check for head
elements that are electrically malfunctioning.
DSW1-4 SETTING
Off 1 Stop Bit
On 2 Stop Bits
12345678
ON
OFF
DSW1
DSW1-5 DSW1-6 SETTING
Off Off 9600
Off On 19200
On Off 4800
On On 2400
12345678
ON
OFF
DSW1
DSW1-7 DSW1-8 SETTING
Off Off Rdy/Bsy
Off On X-On/X-Off
On Off Bi-Com
On On Not Used
12345678
ON
OFF
DSW1
DSW2-1 SETTING
Off Therm Xfr
On Direct Therm
12345678
ON
OFF
DSW2
DSW2-3 SETTING
Off Disabled
On Enabled
12345678
ON
OFF
DSW2
Section 3. Printer Configuration
SATOXL SeriesPrinters9001038 Rev. DPage 3-3