Operator`s manual

POWERING ON/OFF
Before Turning Power Off
When removing power from the printer, you should first feed any printed labels or
tags out of the printer by pressing the EJECT key while the printer is On Line. Any
tags printed but still in the printer will be fed out, cut and the tag/label retracted to
place the first print line under the head.
Note: The EJECT operation can be controlled via software commands from the host.
After the printed labels have been ejected from the printer, place the printer in the
OFF LINE state before removing power. If the label/tag position is not disturbed
while power is off, then the first printable label/tag will be in the correct position
when power is reapplied. The Media Type setting is retained in the printer even
though power is removed. When power is reapplied, the first print line of the
tag/label will be correctly positioned under the print head.
Replenishing the Tag Supply
When replenishing the tag/label supply with the same type and size, it is not
necessary to power the printer off. The printer will automatically position the new
media to the correct position.
• Raise the print head and relatch it to clear the “Paper End” Error.
• Unlatch the Media Hold Down and position the leading edge of the
media even with the mark on the “Tag Setting Position” label. If labels are
SATO XL PRINTER
Total number of labels to be printed. Will
decrement each time a label is printed.
Total number of labels printed. Will increment
each time a label is printed since the last
time the printer was powered On.
Section 2. Installation
SATOXL SeriesPrinters9001038 Rev. DPage 2-21