Operator`s manual

After adjusting the Cutter Sensor, make sure you:
• Have the media and ribbon loaded correctly.
• The media and ribbon type are correct for the configuration.
• The Print Head and Media Hold Down are latched in the closed position.
• The cover is closed.
NOTES:
If the media is not positioned correctly, press the FEED key to realign it.
If power is removed while printing, the media may be incorrectly positioned when power
is restored and the printer may print several blank tags. Press the Start/Stop key to
pause the print job and turn power off. When power is reapplied, the printer will
correctly position the tags.
Sensor Adjustment
Thumbscrew
After adjusting the Cutter Sensor Assembly, tighten the Sensor Adjustment
Thumbscrew and close the Cover.
Cover
Section 2. Installation
Page 2-209001038 Rev. DSATOXL SeriesPrinters