Operator`s manual

Notch
See Tag Charts on pages 2-8 to 2-9 if you
are unsure about tag type.
If you are using R-Corner Notch Tags, the tag notch must be on the inside edge of the
tag and the position the Sensor Select Switch should be towards the outside of the
printer. For all other tags, the Sensor Selector Switch should be towards the inside of
the printer.
R-Corner Other Tag
Scale
R-Corner: . . Inside scale, 32 to 42mm.
Center-Hole: . Black scale
........ Other Tag, 47 to 100mm
........ R-Corner, 32 to 42mm
Side Hole: . . Blue scale, 50 to 100mm
See Tag Charts on pages 2-8 to 2-9 if you
are unsure about tag type.
The scale used depends upon the type of media selected (i.e. R-Corner, Center-Hole or
Side-Hole) and the setting corresponds to the width of the media (i.e., if you are using
center hole tags that are 80mm wide, the notch should be set at the 80mm mark of the
black scale).
Section 2. Installation
SATOXL SeriesPrinters9001038 Rev. DPage 2-19