Operator`s manual

CUT SENSOR ADJUSTMENT
These adjustments are for R-Corner Tag (Side-Notch), Center-Hole and Edge-Hole
tags only.
Cover
Cutter
Sensor
Assembly
Open the cover. The Cut Sensors are located on an adjustable assembly that must be
correctly positioned for the type of media used. They must be adjusted correctly even
though the Cutter is disabled. If they are not, a “Cutter Error” will result when you try to
feed tags.
Loosen the green Sensor Adjustment Thumbscrew on the Cutter Sensor assembly.
Align the notch on the Cutter Sensor Assembly to the position of the tag registration
mark using the scale.
Sensor
Adjustment
Thumbscrew
Section 2. Installation
Page 2-189001038 Rev. DSATOXL SeriesPrinters