Operator`s manual

Cover
Head Lock Lever
Make sure the media is fed into the printer with the leading edge underneath the print
head. Close and latch the print head in the down position by rotating the Head Latch.
Power the printer On. Press the Start/Stop key to initiate the automatic media feed.
If the Media Type setting is incorrect, a “Sensor Error” will be displayed on the LCD.
If this occurs, you must open the print head and Media Hold Down, reposition the
media, close the print head and Media Hold Down and select the correct media type
by pressing the Media Type key (see page 2-8). Press the Start/Stop key.
Start/Stop Key
Note: If you get a “Cutter Error,” you
must correctly position the Cut Sensor.
See page 3-20. This can occur even if
the Cutter is disabled.
Section 2. Installation
SATOXL SeriesPrinters9001038 Rev. DPage 2-17