Operator`s manual

Close and latch the Media Hold Down and then close the Cover.
Refer to Ribbon Loading in this section if
there is no ribbon in the printer.
Start/Stop Key
Ejected Tags
Close the Media Hold Down by pushing down on the green tab marked “PUSH.” It will
automatically latch in place. Close the print head by rotating the Head Lock Lever toward
the front of the printer until it latches in place.
Power the printer On and press the Start/Stop key. The tags should be ejected if the
Media Type setting is correct (the factory setting is Center-Hole Tag, however the printer
retains the last setting entered via the LCD Panel). If the Media Type setting is incorrect, a
“Sensor Error” will be displayed on the LCD. If this occurs, you must open the print head
and Media Hold Down, reposition the media, close the print head and Media Hold Down
and select the correct media type by pressing the Media Type key (see page 2-8) and
press the Start/Stop key.
Note: If you get a “Cutter Error,” you must
correctly podsition the Cut Sensor. See
page 2-19. This can occur even if the
Cutter is disabled.
Cover
Media Hold Down
Section 2. Installation
Page 2-149001038 Rev. DSATOXL SeriesPrinters