Operator`s manual

Media Hold Down
Head Lock Lever
Media Hold Down
Head Lock Lever
Sensor Label
Tag
Paper Guide Lock Screw
Paper Guide
Load the tags from the rear until the leading edge of the first tag is underneath the print
head. Loosen the Paper Guide Lock Screw and adjust the position of the Paper Guide
until it holds the tag gently against the inside of the paper path (this also positions the
sensor assembly). Retighten the Paper Guide Lock Screw. See page 2-11 for sensor
locations.
Tag Setting
Position
Open the print head by rotating the Head Release Lever to the rear of the printer. Open
the Media Hold Down by lifting up on the release tab underneath the green tab marked
“PUSH.”
Section 2. Installation
SATOXL SeriesPrinters9001038 Rev. DPage 2-13