Operator`s manual

LOADING TAGS AND LABELS
Turn power on and open the cover.
Remove the Media Retaining Plate and load the tag roll.
Power Switch
Cover
Tag Roll
Media Retaining Plate
Media Supply Spindle
Remove the Media Retaining Plate and
place the media roll on the Media Supply
Spindle. Replace the Media Retaining Plate
to secure the roll in place.
Note: The media should come off the
bottom of the roll (wound face-in). If
media is used that is wound face-out, the
label curl can cause problems with the
stacking of the labels.
Open the Cover and power the printer on.
Section 2. Installation
Page 2-129001038 Rev. DSATOXL SeriesPrinters