Operator`s manual

6. Turn the printer on and make sure the cutter is enabled and the tags aligned for
printing.
Note: If the tag sensors are not aligned properly, the printer feeds out a
length of tag stock without cutting it as it is attempting to determine the tag
pitch (length). Temporarily move the Stacker unit to one side if this occurs
until the sensors are correctly set and the tags are at the proper position.
See Section 2 for instructions on loading and aligning the tags.
7. Send the print job to the printer and let it cut and stack a few tags. The temporarily
stop the printer by pressing the START/STOP key and check to make sure the
tags are being stacked under the Tag Hold Down and that the Tag Stop and
Tag Edge Guide are proper ly set.
8. When proper operation has been verified, place the printer back ON LINE by
pressing the START/STOP key again to finish the print job.
9. The printer will automatically stop and go OFF LINE when the Stacker is full. When
this happens, remove the tags and finish the print job by pressing the
START/STOP key to place the printer back ON LINE.
CALENDAR
The Calendar Option allows the date and time to be maintained in the local printer
rather than using the system clock. A qualified technician should perform the upgrade
as it requires modifications to the main PCB assembly. Please call SATO Technical
Support if you need to add this option to an existing printer in the field.
Appendix D: Optional Features
Page D-69001038 Rev. DSATOXL SeriesPrinters