Operator`s manual

UNPACKING AND PARTS IDENTIFICATION
Consider the following when unpacking the printer:
• The box should stay right-side up.
• Lift the printer out of the box carefully.
• Remove the plastic covering from the printer.
• Remove the accessory items from their protective containers.
• If the printer has been stored in a cold environment, allow it to reach room
temperature before powering it on.
• Set the printer on a solid, flat surface. Inspect the shipping container and
printer for any sign of damage that may have occured during shipping.
Note: The following illustrations are representative only. Your printer may not be packed
exactly as shown, but the unpacking steps are similar.
Cardboard Cover
XL Printer
Accessory Box
Plastic Protective
Shipping Container
Top Foam Inserts
Bottom Foam Inserts
Section 2. Installation
Page 2-29001038 Rev. DSATOXL SeriesPrinters