Operator`s manual

Media Size
Command Structure <ESC>A1aabbbccc
aa = Media Type
0T Center Hole, Side Hole, R-Corner or I-Mark tag
0L I-Mark or Gap label
bbb = Pitch Size in mm
025 - 120 Tag
019 - 120 Label
025 - 240 Tag
019 - 240 Label
cc = Media Width in mm
032 - 080 Tag
025 - 080 Label
032 - 100 Tag
025 - 100 Label
Example: <ESC>A1OT060042
Placement: Preceding the print job
Default: None
Command Function Checks if the Media Size specified in the job stream matches the
media size detected by the printer. DSW2-8 must be ON for this
command to work.
Input to Printer
<ESC>A
<ESC>A1OT038076
<ESC>Z
<ESC>A<ESC>V0100<ESC>H0400
<ESC>P2<ESC>L0202<ESC>XMABCD
<ESC>Q3<ESC>Z
Printer Output There is no printer output as a result of this command.
Special Notes 1. A Media Size error will occur is the pitch and width sent by the
command does not match that measured by the printer.
2. If a Media Error occurs, you must either load the correct size media
or reset the printer by powering it Off.
Section 5. Programming Reference
Page5-469001038Rev.DSATOXLSeriesPrinters