Instruction manual

Section 3: Configuration and Operation
Page 3-50 TH2 Series Operator Manual
3.7 PRINTER SETUP MENU (Cont’d)
Below is a table listed the availability of the Backfeed Mode selection based on the Media Handling selection.
Menu Description
BACKFEED MODE setting controls the media backward motion.
Displays existing BACKFEED MODE selection and enables new selection.
The default Backfeed Mode is set at 1.Before
The “pressed radio button” indicates the current selection until the new selec-
tion is chosen and enter button is pressed.
Note:
The view of the Backfeed Mode menu is depended of the Media Handling
selection.
After changing Backfeed Mode, the first label will be incorrectly positioned. To
avoid this, press pause/feed button in order to let the media positioning cor-
rectly before printing.
MEDIA HANDLING
Tear Off Continuous Peel Off Cutter LL Tear Off LL Cutter
BACKFEED
MODE
Before ! ! ! ! !
After ! !
None ! ! !
Menu Description
ADJUSTMENT menu.
Media ADJUSTMENT handles the formats positioning and appearance on the
media.
Enables the selection of 1.Pos Adjust, 2.Pitch or 3.Offset.
The POS ADJUST (Position Adjustment) enables tuning the media stop posi-
tion. It is very useful if the I-Mark is not located according to media specification.
The value can be expressed in inches, millimeters or dots depending on selec-
tion in UNIT menu.
Displays the Position Adjustment range and input field with existing media
length and its unit.
Enables input of new media length.
Setting range is between -200 and 200, and the default value is 0 dot.
Note:
If the value is outside the allowed range, Invalid will be displayed.
If the value is acceptable, Saved will be displayed when enter button is
pressed.