Instruction manual

Section 3: Configuration and Operation
TH2 Series Operator Manual Page 3-45
3.7 PRINTER SETUP MENU (Cont’d)
Below is a table listed the availability of the sensor type selection based on the Media Handling selection.
MEDIA HANDLING
Tear Off Continuous Peel Off Cutter LL Tear Off LL Cutter
SENSOR
TYPE
Gap ! ! ! ! !
I-Mark ! ! ! ! ! !
None ! ! ! !
Fix ! ! ! !
Menu Description
MEDIA menu.
Enables the selection of 1.Size, 2.Sensor Type, 3.Calibrate or 4.Max feed.
Select 3.Calibrate to calibrate media sensor to its best performance with the
loaded media.
Note:
During calibration, the “Auto feed on error” is neglected even when it was
enabled in Print control set up.
If “Auto feed on error” is active, there is a risk of entering a never ending loop if
the calibration for some reason is aborted or un-successful.
When calibration is done, “Auto feed on error” returns to active if it was enabled
in Print control set up.
Enables the selection of 1.I-Mark or 2.Gap for calibration.
The printer sensors are factory calibrated.
If media that is significantly different from standard is used, a sensor calibration
might be necessary.
1. Load the printer with media intended for use.
2. Start with the VR1 in center position for calibrating I-Mark sensor, or set the
VR2 to center position for calibrating Gap sensor.
3. Select 1.I-Mark or 2.Gap in CALIBRATE menu accordingly.
4. When enter is pressed, the printer will feed a few labels.
The printer will start auto calibration on the selected media sensor.
5. If calibration was not successful, you will be recommended to re-adjust VR1
or VR2 manually.
6. Press pause/feed button to check if new sensor level is OK.
This procedure may need to be repeated to obtain successful calibration result.