Instruction manual

Section 2: Installation
TH2 Series Operator Manual Page 2-7
2.4 CONNECTIONS
This section explains the power cable and interface cable connection procedures.
2.4.1 Standard interface connection
TH2 Series printers have three types of Main PCBs, and each type of PCB is equipped with a different type of
interface to perform data communication with the host. These are described as follows.
1) Type 1: USB on-board
2) Type 2: USB and LAN on-board
3) Type 3: Wireless LAN on-board
Use the cable that is compatible with the standard of the interface board as stated in Section 7: Interface
Specifications. Make sure the cable is correctly oriented.
2.4.2 To activate the connected interface
When using LAN or WLAN as connection to the host PC, you may need to set the configuration on the
PRINTER SETUP menu. Please refer to Section 3.7.6 When Network is selected in the SETUP menu
(LAN) or Section 3.7.7 When Network is selected in the SETUP menu (Wireless LAN) for details.
Caution
Never connect or disconnect interface cables (or use a switch box) with power applied to either the host
or printer. This may caused damage to the interface circuitry in the printer/ host and is not covered by
warranty.
Type 1: USB on-board
Type 2: USB and LAN on-board
Type 3: Wireless LAN on-board
LAN
USB
Host