Instruction manual

Section 2: Installation
Page 2-6 TH2 Series Operator Manual
2.3 LOADING MEDIA (cont’d)
5. Close the top cover until it snaps into position.
6. After loading the media, press power button to turn
on the power if printer is turned off. If printer is on, press
C button to clear Cover open error.
When the printer is ready, press the pause/ feed
button to output an empty label and stop at the
dispenser. This procedure is to ensure that the label is
loaded correctly.
Notes:
• There may be cases when the dispenser does not func-
tion properly due to the thickness of the labels used.
• The Dispenser unit is effective for label pitch 16 to 120
mm (0.6” to 4.7”) long. However, the label size limitation
may vary with application conditions.
• Labels over 100 mm (3.9”) long may curl at dispenser
due to the nature of the material. There is no remedy for
this.
2.3.3 Overview of the Roll media loading path
Caution
• When replacing media, bear in mind that the print head and its surrounding area remain hot.
Keep your fingers away from these areas to prevent injury.
• Avoid touching even the edge of the print head with your bare hands.
Output label
Output
liner
Label path
Backing liner
path for use
with dispenser