Instruction manual

Section 2: Installation
TH2 Series Operator Manual Page 2-5
2.3 LOADING MEDIA (cont’d)
2.3.2 To route the label when using the dispenser
1.
Follow the procedures in Section 2.3.1 Loading Roll media, from step 1 to 4, to load the roll media onto
the media holder.
2. Pull the two corners of the pressure bracket out to open
the pressure bracket.
3. Peel off the first two leading labels from the liner (back-
ing paper) and then pull out the leading liner (backing
paper) from the media holder.
Pass the liner (backing paper) over the dispenser plate
so as to cover it. Then pass the liner (backing paper)
under the pressure bracket as shown.
4. If the paper is not taut, roll the paper on the media
holder so that the paper is taut.
Next, tightly close the pressure bracket with the liner
(backing paper) passing through it.
Pressure
bracket
Dispenser plate
Dispenser unit
Media guides
Dispenser
plate