Instruction manual

Section 8: Appendix
TH2 Series Operator Manual Page 8-7
8.3 OPERATION MODE SELECTION (cont’d)
8.3.3 Dispensing Mode (cont’d)
Motion 2 (Backfeed set to Before)
When printing starts (A. in the figure below), the media is in a position so that the previous label could be
removed.
Before printing label 1, the media has to be back fed so that label 1 is in the printing start position (B. in the
figure below).
When label 1 is printed, the media is fed forward so it can be removed (C. and D. in the figure below).
When label 1 is removed the printer is ready to start printing label 2.
Dispensing pin
B. Media fed
back to
printing start
position
A. Before
printing
Feed
direction
2
3
1
3
2
1
Print head
C. Label 1 is
printed
3
4
2 1
D. Label 1 is
stopped just
before the
dispensing pin.
1