Owner`s manual

8
2.10 Test Printing
A test print should be performed to ensure that the printer is operating correctly.
1. Use label stock for best results (test print may be performed on tags
but may not be as clear).
2. Turn the printer off.
3. Hold down the FEED and PAUSE key and turn the machine on, (1)DIAG
will appear.
4. Press the FEED key until (4)TEST PRINT appears.
5. Press the PAUSE key and PRINT CONDITION will appear.
6. Press PAUSE and ISSUE COUNT will appear.
7. Press the FEED or RESTART key until the desired quantity is selected.
8. Press PAUSE and PRINT SPEED will appear (leave this setting as is).
9. Press PAUSE and SENSOR TRANS will appear (leave this setting as is
unless you are test printing on plastic tags then set it to REFLECT by
pressing RESTART).
10. Press PAUSE and PRT TYPE TRANSFER will appear (leave this setting
as is).
11. Press PAUSE and TYPE [S] NO CUT will appear (leave this setting as
is).
12. Press PAUSE and LABEL LEN. 76mm will appear. Change this setting
according to the size of labels that are being printed by pressing the
FEED or RESTART keys.
13. Press PAUSE and PAPER FEED will appear.
14. Press PAUSE and the printer will present one blank label and display
(4) TEST PRINT.
15. Press PAUSE and the printer will display PRINT CONDITION.
16. Press RESTART until SLANT LINE (3 DOT) appears.
17. Press PAUSE and the requested number of labels will print out with a
slanted line pattern.