Owner`s manual

2.4 Cable Connection

The following cables will be needed for installation:

• 1 serial cable if the printer only has a serial RS232

connector.

• 1 parallel cable to connect to the computer’s printer

port.

• 1 RJ45 cable is needed if the optional LAN board is

installed.

• 1 USB cable is needed if using a USB port.

• 1 power cord.

2.5 Connecting the power cord

• Make sure the printer is in the OFF position.

• Connect the power cord to the printer.

• Plug the other end of the power cord into a grounded outlet.

2.6 Turning the printer ON and OFF

• To turn on the printer, press the switch on the back side of the printer above

the power cord.

• Make sure the front display reads ONLINE and the green power LED is on.

• To turn off the printer just press the switch in the opposite direction.