Technical data
Table Of Contents
- 0. i Cover B
- 0. i Copyright B
- 0. i TOC B
- 1. i Introduction B
- 2. i Programming Concepts B
- 3. i Code Quick Reference B.backup
- 4. i Standard Command Codes B
- 5. i Optional Command Codes B
- 6. i Bi-Directional Communications B
- 7. i Appendix B
- 7
- appendix
- custom graphics
- CUSTOM GRAPHICS EXAMPLE
- 1. Determine the matrix size for the graphic. It must be in 8 dot by 8 dot blocks. The example here has six blocks horizontally and six blocks vertically (48 x 48).
- 2. Lay out a grid and draw the image on the grid.
- 3. Transfer the image into a bit map representation and then into hexadecimal format:
- 4. Using the hexadecimal data, send the following code to print the graphic image as designed.
- 5. To send the data in binary format, the software must convert the data into binary format before transmitting it to the printer. Using the BASIC programming language for example, this is done by notation “CHR$ (&HC0)” which sends the hexidecima...
- PCX GRAPHICS EXAMPLE
- CUSTOM GRAPHICS EXAMPLE
- printer configuration commands
- reference tables
Unit 5: Optional Command Codes
“i” Programming Reference
5-3 PN: 9001158B
AUTHENTICATION MODE, CONFIGURATION
FUNCTION
Specifies the parameters related to Bluetooth authentication mode search and connectivity.
FORMAT
<ESC>I7abcde
a=
Authentication mode
0: None (1 digit fixed)
1: Level 2-1
2: Level 2-2
3: Level 3
b=
ISI in Hexadecimal (0015 to 1000, 4-digits fixed)
c=
ISW in Hexadecimal (0012 to 0997, 4-digits fixed)
d=
PSI in Hexadecimal (0015 to 1000, 4-digits fixed)
e=
PSW in Hexadecimal (0012 to 0997, 4-digits fixed)
Place after <ESC>A and before <ESC>Z.
EXAMPLE
<ESC>A
<ESC>I700800010008000036
<ESC>Z
OUTPUT
This command does not result in printer output.
NOTES
This command is only valid for printers conforming to Bluetooth specifications.
This command must be preceded by the <ESC>A command and followed by the <ESC>Z command in
a separate string and cannot be used in conjunction with other commands.
This command becomes valid upon restarting of the printer.
The default settings are as follows:
Authentication Mode: None
ISI: 0800
ISW: 0700
PSI: 0800
PSW: 0100
When restarting the printer after command execution, the command contents will be processed for
Bluetooth interface. The printer will go into sleep mode after completing the settings and the printer can
then be powered off. Do not power off the printer until it has gone into sleep mode.