Technical data
Table Of Contents
- 0. i Cover B
- 0. i Copyright B
- 0. i TOC B
- 1. i Introduction B
- 2. i Programming Concepts B
- 3. i Code Quick Reference B.backup
- 4. i Standard Command Codes B
- 5. i Optional Command Codes B
- 6. i Bi-Directional Communications B
- 7. i Appendix B
- 7
- appendix
- custom graphics
- CUSTOM GRAPHICS EXAMPLE
- 1. Determine the matrix size for the graphic. It must be in 8 dot by 8 dot blocks. The example here has six blocks horizontally and six blocks vertically (48 x 48).
- 2. Lay out a grid and draw the image on the grid.
- 3. Transfer the image into a bit map representation and then into hexadecimal format:
- 4. Using the hexadecimal data, send the following code to print the graphic image as designed.
- 5. To send the data in binary format, the software must convert the data into binary format before transmitting it to the printer. Using the BASIC programming language for example, this is done by notation “CHR$ (&HC0)” which sends the hexidecima...
- PCX GRAPHICS EXAMPLE
- CUSTOM GRAPHICS EXAMPLE
- printer configuration commands
- reference tables
Unit 4: Standard Command Codes
“i” Programming Reference
4-50 PN: 9001158B
IRDA INTERFACE, DEVICE NAME CONFIGURATION
FUNCTION
Specifies the applicable IrDA device name.
FORMAT
<ESC>I3a-a
a=
Device name in alphanumeric characters (1 to 32)
Place between <ESC>A and <ESC>Z.
EXAMPLE
<ESC>A
<ESC>I3PETIT-LAPIN
<ESC>Z
OUTPUT
This command does not result in printer output.
NOTES
Use this command with a <ESC>A and <ESC>Z separately. This command cannot beused in
conjunction with other commands.
Settings can be confirmed by performing a test print.
This command becomes valid when the printer is powered on again.
The default setting is as follows: Device name, SATO MOBILE PRINTER.