Technical data
Table Of Contents
- 0. i Cover B
- 0. i Copyright B
- 0. i TOC B
- 1. i Introduction B
- 2. i Programming Concepts B
- 3. i Code Quick Reference B.backup
- 4. i Standard Command Codes B
- 5. i Optional Command Codes B
- 6. i Bi-Directional Communications B
- 7. i Appendix B
- 7
- appendix
- custom graphics
- CUSTOM GRAPHICS EXAMPLE
- 1. Determine the matrix size for the graphic. It must be in 8 dot by 8 dot blocks. The example here has six blocks horizontally and six blocks vertically (48 x 48).
- 2. Lay out a grid and draw the image on the grid.
- 3. Transfer the image into a bit map representation and then into hexadecimal format:
- 4. Using the hexadecimal data, send the following code to print the graphic image as designed.
- 5. To send the data in binary format, the software must convert the data into binary format before transmitting it to the printer. Using the BASIC programming language for example, this is done by notation “CHR$ (&HC0)” which sends the hexidecima...
- PCX GRAPHICS EXAMPLE
- CUSTOM GRAPHICS EXAMPLE
- printer configuration commands
- reference tables
Unit 4: Standard Command Codes
“i” Programming Reference
4-45 PN: 9001158B
OFFSET
FUNCTION
Temporarily specifies the label stop position for each mode of operation.
FORMAT
<ESC>POabcc
a=Offset
0: Not used
1: Dispenser mode
2: Tear-Off mode
3: Label pitch
b = Offset direction
+: Advance label feed
-: Retract label feed
c = Offset range in dots (00 to 99)
Place after <ESC>A but before <ESC>V.
EXAMPLE
<ESC>A
<ESC>PO3+08
<ESC>Z
OUTPUT
This command does not result in printer output.
NOTES
This command is not required to be specified for normal print operation.
(4-29)
Top of Form
+8
+0
TEXT
TEXT