Technical data
Table Of Contents
- 0. i Cover B
- 0. i Copyright B
- 0. i TOC B
- 1. i Introduction B
- 2. i Programming Concepts B
- 3. i Code Quick Reference B.backup
- 4. i Standard Command Codes B
- 5. i Optional Command Codes B
- 6. i Bi-Directional Communications B
- 7. i Appendix B
- 7
- appendix
- custom graphics
- CUSTOM GRAPHICS EXAMPLE
- 1. Determine the matrix size for the graphic. It must be in 8 dot by 8 dot blocks. The example here has six blocks horizontally and six blocks vertically (48 x 48).
- 2. Lay out a grid and draw the image on the grid.
- 3. Transfer the image into a bit map representation and then into hexadecimal format:
- 4. Using the hexadecimal data, send the following code to print the graphic image as designed.
- 5. To send the data in binary format, the software must convert the data into binary format before transmitting it to the printer. Using the BASIC programming language for example, this is done by notation “CHR$ (&HC0)” which sends the hexidecima...
- PCX GRAPHICS EXAMPLE
- CUSTOM GRAPHICS EXAMPLE
- printer configuration commands
- reference tables
Unit 7: Appendix
“i” Programming Reference
7-31 PN: 9001158B
TABLE 23: PARAMETERS (<ESC>PG)
# ITEM DESCRIPTION
a Print Speed 1: 75mm/sec (maximum)
2: 103mm/sec (maximum)
b Print Darkness Level 1: Lightest
2: Light
3: Normal
4: Dark
5: Darkest
c Print Darkness Range A through C
d Backfeed 1; Motion 1 (head position)
2: Motion 2 (dispensing position)
3: No backfeed
e Zero Slash 0: Disable
1: Enable
f Kanji code 0: JIS code
1: Shift JIS code
g Initial Feed 0: Disable
1: Enable
h Proportional Pitch 0: Release of Proportional Pitch
1: Designation of Proportional Pitch
i Label Height 0001 to 1280 dots
j Label Width 0001 to 0384 dots (4 digits)
k Vertical Start Point Correction Digit 1: +/- (4 digits)
Digits 2-4: 000 to 300
l Horizontal Start Position Correction Digit 1: +/- (4 digits)
Digits 2-4: 000 to 300
m Label Pitch Offset Digit 1: +/- (3 digits)
Digits 2-4: 00 to 99
n Tear-Off Offset Digit 1: +/- (3 digits)
Digits 2-4: 00 to 99
o Dispenser Offset Digit 1: +/- (3 digits)
Digits 2-4: 00 to 99
p Auto Power Off 000: No auto power off (3 digits)
001 to 999 minutes
q Print Mode 0: Label Print Mode (1 digit)
1: Journal Print Mode
2: 2-Color Label Print Mode
3: 2-Color Journal Print Mode
4: Linerless Print Mode
r Print Operation Mode 0: Tear-Off (1 digit)
1: Continuous
s Sensor Type 0: Eye-Mark Sensor (1 digit)
1: Gap Sensor